Directions to Crescent
From York (PA) and points north:
Take Interstate 83 South to Exit 4 - Shrewsbury. At bottom of ramp, turn right onto 851 West. Travel approximately ¾ Mile to 3rd signal light and turn left onto Main Street. Travel approximately 1 ½ Miles to next signal light and turn right onto Constitution Avenue and go to 2nd stop sign. Crescent Industries Molding Plant & General offices are directly in front of you.
Do you want to go to the MOLDING PLANT or the TOOLING PLANT?
Molding Plant (70 East High Street)
At the stop sign, Crescent Industries Molding Plant and General Offices are directly in front of you. Turn right onto High Street and make immediate left into our parking lot. The Shipping and Receiving docks are on your left along the side of the building.
Tooling Plant (12 North Front Street)
After turning right onto Constitution Avenue go to the 1st stop sign and make a right onto Main Street in New Freedom. Crossover the railroad tracks and turn right onto Front Street, Crescent’s Tooling facility is located on the left side of the street.
From Baltimore (MD) and points south:
Get to Baltimore Beltway Route 695 and take Interstate 83 North (Exit 24 off the beltway). Travel about 30 Miles North on I-83 take Exit 4 - Shrewsbury that is the first exit in Pennsylvania. At bottom of ramp, turn left onto 851 West. Travel approximately ¾ Mile to 4th Signal light and turn left onto Main Street. Travel approximately 1 1/2 miles to next signal light and turn right onto Constitution Avenue and go to the 2nd stop sign. Crescent Industries Molding Plant and General Offices are directly in front of you.
Do you want to go to the MOLDING PLANT or the TOOLING PLANT?
Follow directions above.
From Philadelphia (PA) and points east:
Take PA Turnpike, Route 76 West to Route 22 South. Take 222 South to Route 30 West at Lancaster. Take 30 West to York. Take Interstate 83 South about 12 Miles to Exit 4 – Shrewsbury. At bottom of ramp, turn right onto 851 West. Travel approximately ¾ Mile to 3rd signal light and turn left onto Main Street. Drive approximately 1 ½ Miles to next signal light and turn right onto Constitution Avenue and go to 2nd stop sign. Crescent Industries Molding Plant & General Offices are directly in front of you.
Do you want to go to the MOLDING PLANT or the TOOLING PLANT?
Follow directions above.
Or click below for door-to-door directions from mapquest:
to Molding Plant - 70 E. High St., New Freedom, PA
to Tooling Plant - 12 N. Front St., New Freedom, PA
Click here to see video of our facilities.