<img alt="" src="https://secure.pair1tune.com/221242.png" style="display:none;">
Skip to content

DFM Checklist: Essential Considerations for Injection Molding

Design for manufacturability is about anticipating what could go wrong and preventing it from occurring. In order to evaluate a product design and anticipate problems in manufacturing, engineers and designers can use a variety of tools, including a design for manufacturability checklist.

Creating a Design for Manufacturability Checklist

A design for manufacturing checklist can be built from a number of different sources of information and can be customized for the particular type of manufacturing project being undertaken. In plastic injection molding, for example, items identified in a mold flow simulation can be used to create a checklist, as well as flaws and problems that the company has encountered with past projects. When issues occur on one project, they should be added to the checklist to prevent the same problem from recurring with subsequent projects.

Once a checklist is established, it becomes a key resource for both contract manufacturers and OEMs in identifying flaws in part design, mold design, material temperature, injection pressure, cooling time, and other parts of the manufacturing process. Nearly all of these types of defects can be predicted and avoided through the design for manufacturability process.

Design for Manufacturability Checklist — Injection Molding

The following parameters should be evaluated for all projects when conducting a design for manufacturability evaluation in plastic injection molding:

  • Maximum pressure: filling
  • Maximum pressure: packing
  • Fill pattern animation
  • Inlet pressure curve
  • Clamp force estimation
  • Increase/decrease in temperature during filling
  • Frozen skin results
  • Shearing rate of the resin, measured in inverse seconds
  • Flow tracer animation
  • Air traps
  • Venting temperature
  • Weld lines
  • Weld line tracer animation (with flow front)
  • pvT chart analysis of weld lines, in order to plot where the material solidifies on the chart at a specified time
  • Material solidification, shown at various stages of part cooling, including gate freeze
  • Sink marks
  • Hot spots
  • Voids
  • Part thickness concerns:
    • Check for thick areas of the part that could result in sinks and voids
    • Check for thin areas of the part that could result non-fill
    • Can the part be made to have a uniform thickness throughout?
  • Material considerations:
    • Is this a resin that does not flow well, requiring long and/or thin flow lengths?
    • Will the material increase in temperature or have excessive shear because of thin part thicknesses?
  • Gate location concerns:
    • Will the gate seal too early, causing sink marks?
    • Can the gate be located in a thick area of the part?
    • Are multiple gates required for flatness, roundness, proper filling based on part geometry and/or material flow?
    • Can gating be executed such that the flow of plastic is impinging on steel, to prevent splay?
  • Part draft concerns:
    • If present, is it in the right direction and location for a good parting line?
    • If texture is being used, is there enough draft to release the texture without scuffing?
    • Does the draft need to be changed/eliminated/reversed in order to hold the part on the ejector side of the mold?
    • Depending on tooling split, draft may need to be a seal-off angle of 3-5°
  • Is there part geometry that will create thin steel conditions in the tool?
  • If there are undercuts on the part, can they be simplified (e.g. pass through coring instead of lifters or actions)?

In addition, the following items should be evaluated on a case-by-case basis, if they apply to the project at hand:

  • Crystallization
  • Fiber orientation
  • Shrinkage and warpage

Receive this checklist in a pdf format. 

By incorporating this design for manufacturing checklist into your plastic injection molding projects, you can identify current and potential problems and fix them in the design phase. Manufacturing can then proceed with the knowledge that you have the right design specifications, manufacturing processes, and tools and equipment selections in place.

Guide to Design for Manufacturability Injection Molding


Go to Top